Panasonic 30″ Microwave Trim Kit for Panasonic 2.2 cu ft Microwave Ovens – NN-TK932SS (Stainless Steel)
Looking for a space-saving solution in your kitchen? Convert your Panasonic 2.2 cu ft countertop microwave oven to a built-in model with the Panasonic NN-TK932SS 30” microwave trim kit. This Trim Kit consists of the trim frame, an upper, lower, and rear duct that attaches to and encases the microwave inside the cabinet cut-out opening to give your kitchen a stylish look while freeing up precious countertop space. The Panasonic NN-TK932SS Trim Kit is designed for use only with the NN-SE9**S | NN-SD9**S | NN-SN9**S | NN-ST9**S Panasonic Microwave Ovens. For safety, unplug the microwave oven before attempting installation of the NN-TK932SS trim kit. Installation of this trim kit requires basic mechanical and electrical skills and may be completed by the DIY homeowner or kitchen cabinetry professional. Proper installation is the responsibility of the installer. The microwave oven must be used with a properly grounded 3-prong receptacle in compliance with the National Electrical code, as well as any applicable local regulations. Also refer to the microwave oven operating instructions for other safety and electrical requirements.
Product Features
- TRIM KIT OUTER SIZE – 760mm or 30″ (W) 472mm or 18 9/16″ (H) 20mm or ¾” (D)
- TRIM KIT INNER SIZE – 24 5/8″ (W) x 13 11/16″ (H)
- CABINET OPENING – 724mm or 28-1/2″ + 8mm or 5/16″ – 0mm (W) 442mm or 17-3/8″ +/- 2mm or 5/64″ (H) minimum 533mm or 21″ (D) and minimum 920mm or 36 ¼” from the floor
- COMPATIBLE MICROWAVE OVENS – This Trim Kit is designed for use only with the NN-SE9**S | NN-SD9**S | NN-SN9**S | NN-ST9**S Panasonic Microwave Ovens
- TOOLS NEEDED – Measuring tape, pencil, Phillips screwdriver, Ø 2 (5 /64″) mm drill
Love this trim kit This was the perfect finishing trim kit for my recently purchased Panasonic NN-SD997S Genius “Prestige” 2.2 cu ft. The installation needed to be customized by me to fit the cabinet where my previous Microwave/convection oven was installed. I liked the way the microwave was vented with this trim kit. I did not use the supplied tape to attach the top vent, but instead used some aluminum duct tape I had on hand. Also, since my opening was not the exact size specified I was unable to use…
Sufficient but poor value If you want the Panasonic oven and you want to install it as a cabinet built in, then this is really your only option and at the end of the project you should be relatively pleased. As others have pointed out in their reviews however the final fit is not uniform and is not as advertised. In the picture of my completed install you can see the same gaps around the oven that others have complained about. In my case the top gap and bottom gap are different as well. If you look close into the gaps…
Misfit, result not as advertised I bought this trim kit because combined with the Panasonic NN-SD972S I could get a decent built-in microwave for less than four hundred, something almost impossible not sure still why, the fact that the plate costs almost the same as the microwave itself doesn’t make any sense.Although the appearance of the plate is good and the instructions ok the problem comes when you realize the opening where the microwave should fit (as seen in the advertised image) is much bigger than the microwave,…