OEM GENUINE FACTORY WHIRLPOOL KENMORE WASHER WATER DRAIN PUMP PART 3363394, 3352293, 3352292

Leak free OEM Pump. First test a success. I ordered this Automatic Washer Water Pump because the one in my Inglis Washer had sprung a leak. Can’t figure out how I got a Canadian made Whirlpool in the US, but it came with the house, so mystery abounds. It was 11 years old and the impeller wheel had finally started to chew through the outside housing making an occasional leak. It was intermittent at best (3 times in 6 years), so it wasn’t a huge concern, until I opened it up to investigate and found the problem.I’ve included…

Went right in in about 1 minute. Taking the washer apart took 10 minutes. Putting it back together took the better part of an hour, but will be quicker next time. You need a large pair of pliers to get the hose clamps off, but other than that, there is nothing difficult about this. Water was leaking from the bottom of my daughter’s washer, so I diagnosed this was the problem, ordered it on the cell phone, and two days later, I was at her apartment fixing it. Other reviews have stated that…

Fixed an aggravating leak. Not horribly hard to install either. Instructions, even videos, are available for free on-line. You can probably do it in about 30 minutes, but mine took about 1.5 hours because I took the time to clean out all the crud that had built up inside the machine over the years. It was well worth the effort though. Hardest part of the whole job is putting the sheet metal back on. It’s a little tricky to get the front tabs in and the sides all aligned at once. Just take your…